HP Insight Dynamics 6.2 Integrity CMS Installation and Configuration Guide

you must execute the command after installing the software
(see HP Insight Dynamics 6.2 Integrity CMS Installation and
Configuration Guide).
On an HP-UX CMS, the optional --clobber or -F option
causes an existing Insight Dynamics database to be
removed without being backed up first. If that option is
not used, then an existing database will be upgraded from
the previous version of Insight Dynamics. This does not
apply to a Microsoft Windows CMS.
NOTE: HP recommends backing up your entire CMS
configuration before upgrading from a previous version
of Insight Dynamics. For details about this and other
upgrade considerations, see the Insight Dynamics
installation guide (HP Insight Dynamics 6.2 Integrity CMS
Installation and Configuration Guide or HP Insight Software
6.2 Installation and Configuration Guide), and review the
notes in the description of the --restore option below.
-F|--clobber
Clear any existing Insight Dynamics database without
backing it up. For more information about how this option
affects vseinitconfig, see the descriptions of the options
-a|--initconfig and -r|--unconfig.
-q|--quiet
Do not display any output. Do not prompt for HP SIM
restart after performing the initial configuration operation.
You can view the console and error output in the log files.
-x restart_sim={true|false}
This option selects whether to automatically restart HP
Systems Insight Manager after initial configuration of
Insight Dynamics. It only applies in combination with the
initial configuration option (-a or --initconfig) or the
“unconfigure” option (-r or --unconfig).
Use -x restart_sim=true to restart HP SIM without
any further prompting after all of the Insight Dynamics
applications are configured. There can be a delay of one
or two seconds after vseinitconfig finishes execution
before HP SIM is ready to respond to mx... commands.
Use -x restart_sim=false to return immediately after
all of the Insight Dynamics applications are configured,
without restarting HP SIM.
If this option is not used, you will be prompted whether
to restart HP SIM after all of the Insight Dynamics
applications are configured.
-r|--unconfig
Remove the installed Insight Dynamics tools from HP SIM.
The existing database and configuration information will
not be removed unless the optional --clobber or -F
option is used.
Important: The optional --clobber or -F option causes
an existing Insight Dynamicsdatabase to be removed
without being backed up first. If you do not perform a
backup of the Insight Dynamics database before executing
this command, you will lose all of your Insight Dynamics
data, including gWLM and Capacity Advisor configuration
and historical data.
On a Microsoft Windows CMS, vseinitconfig -r is
automatically invoked by the installer. On an HP-UX CMS,
39