HP- UX Utilization Provider Release Notes A.01.08.08.00

Compatibility and installation requirements
This section describes the compatibility information and installation requirements for this release.
Utilization provider uses hp-ux swinstall –s command for installation, and swremove
command for uninstallation. Specific installation instructions are explained below.
1. To install Utilization Provider on your system use:
swinstall -s up_depot_path
2. To uninstall Utilization Provider on your system use:
swremove utilProvider
Required software
Utilization Provider A.01.08.08.00 requires the following software listed in Table 7 (page 5)
Table 7 Required Software
Supported PlatformProduct versionProduct
HP-UX 11i v1, HP-UX 11i v2, and HP-UX 11i
v3 systems.
A.02.07 or laterWBEM Services
You can download the software from the following web site at:
http://www.hp.com/go/softwaredepot
Enter Utilization Provider in the Search box at the top of the page, and press Enter.
Operating system and version compatibility
This release is specific for HP-UX 11i v3 (B.11.31).
Hardware requirements
Utilization Provider supports PA-RISC and Itanium based system.
Table 8 (page 5) lists the supported platforms, and OS.
Table 8 Utilization Provider supported platform and OS
Mode of deliverySupported OSProduct nameProvider
ISUHP-UX 11i v1, HP-UX 11i
v2, and HP-UX 11i v3
utilProviderUtilization Provider
Required disk space
Make sure at least 12 MB disk space is available on your system to install the Utilization Provider
A.01.08.08.00
Software availability in native languages
The Utilization Provider product is available only in the English language.
Support and other resources
This chapter contains support information and the available resources for the Utilization Provider
Release Notes.
Compatibility and installation requirements 5