HP Insight Management 7.0 Support Matrix

Table 23 HP NonStop servers (continued)
Insight Control
VCEMMatrix OEvirtpwrperfmigrdeplSIMServer model
N/A✓
2
✓Integrity NonStop NS1x00
N/A✓Integrity NonStop S-Series servers
1
The Power ON/OFF and Set Power Level Actions of the Data Center Power Control (DCPC) capability of power
management are not supported for this server.
2
Power and thermal monitoring is not supported for this server.
Table 24 HP Integrity BladeSystem servers
Insight Control
VCEM
Matrix OE
2
3
virt
pwr
1
perfmigrdeplSIMServer model
✓✓✓✓✓
4
✓Integrity BL860c
✓✓✓✓
6
✓
5
✓Integrity BL860c i2
✓✓✓✓✓
4
✓Integrity BL870c
✓✓✓✓
6
✓
5
✓Integrity BL870c i2
✓✓✓✓
6
✓
5
✓Integrity BL890c i2
1
To use Insight Control power management, you must apply an iLO license to the server.
2
Matrix recovery management does not support Integrity servers.
3
For physical systems, all HP Integrity BladeSystem servers with Virtual Connect, all supported Ethernet adapters, and all
supported FibreChannel and FCoE host bus adapters can be used with Integrity/HP-UX cross-technology logical server
operations. However, for VM hosts, only HP Integrity BladeSystem servers and rack-mounted HP Integrity servers (including
Superdome 2), all supported Ethernet adapters, and QLogic 4Gb and 8GB FibreChannel host bus adapters are supported.
4
For direct attached storage (DAS), only RAMOE 1 configuration is supported.
5
For BladeSystem Integrity i2 servers, only Windows 2008 R2 deployments are supported. The servers require minimum
system firmware version 01.80 and management firmware version 01.41.01.
6
The Power ON/OFF actions of DCPC are not supported for this server
28 Managed system hardware and firmware requirements