HP Toptools for Servers v5.0 Administrator Guide

Appendix A Customizing HP NetServer Agents and DMI Software
43
snmp monitor= control=
This instructs SNMP to allow get and set operations for any machine (in case they
haven't already been allowed).
To customize which agents and services are loaded, you must first run the
unmodified NSALOAD.NCF file once. This ensures that the NSALOAD1.NCF
will be created properly. You can then edit the NSALOAD.NCF and comment out
the "load nsamkncf" line (using either a '#' or ';'' character). Next, you can edit the
NSALOAD1.NCF file and comment any line you wish. Refer to the readme file
for a description of each file and its function.
Deinstallation and Reinstallation of HP NetServer
Agents for SCO UNIX
While in system maintenance (single user) mode, the SCO driver and programs
can be deinstalled using the Remove option in the Custom utility. They may then
be reinstalled using the Install option, although it is safest to remove drivers and
programs first before attempting reinstalling them.
After removing packages, be sure to re-link the kernel through the Custom menu,
or by entering the following command at the prompt:
/etc/conf/cf.d/link_unix
Reboot the system using the init 6 command for your changes to take effect.