HP LP2065 20" and HP LP2465 24" LCD Monitors User Guide - Accessibility Enhanced
Table Of Contents
- Contents
- Product Features
- Safety and Maintenance Guidelines
- Setting Up the Monitor
- Operating the Monitor
- Troubleshooting
- Technical Specifications
- Agency Regulatory Notices
- Federal Communications Commission Notice
- Declaration of Conformity for Products Marked with the FCC Logo (United States Only)
- Materials Disposal
- Canadian Notice
- Avis Canadien
- European Union Regulatory Notice
- Disposal of Waste Equipment by Users in Private Household in the European Union
- Japanese Notice
- Korean Notice
- Power Cord Set Requirements
- LCD Monitor Quality and Pixel Policy
3
Setting Up the Monitor
To set up the monitor, ensure that the power is turned off to the
monitor, computer system, and other attached devices, then
follow the instructions below.
✎
Be sure the master power switch, located on the rear panel of the
monitor, is in the off position. The master power switch turns off
all power to the monitor.
Installing the Monitor Pedestal
✎
Do not install the pedestal if the monitor will be used on a wall,
swing arm, or other mounting fixture; instead see the section on
“Mounting the Monitor” in this chapter.
1. Using both hands, position the monitor over the pedestal
base.
Ä
CAUTION: Do not touch the surface of the LCD panel. Pressure on
the panel may cause non-uniformity of color or disorientation of the
liquid crystals. If this occurs the screen will not recover to its normal
condition.
User Guide 3–1