Installation Guide: OpenSAF

2-2-1 Configuring each node in the cluster
By defaul
t, Fedora 10 enables a firewall that blocks the ports that OpenSAF uses to communicate.
Proper firewall configuration is outside the scope of this installation guide. This installation guide only
covers installation of a non-production development cluster where external security is not an issue, as
this guide documents how to disable the firewall entirely, this is not recommended for a production or
publicly connected server. Please see the appropriate distribution documentation on how to open
ports 5003 (as defined in /etc/opensaf/rde.conf).
To disable the firewall, perform the following steps:
1. Login to every node in the cluster as root and enter the following:
# setup
2. Select “Firewall configuration”. Next, select ”Run Tool”.
3. Highlight the “[*] Enabled” line and press the spacebar to unmark the selection. Press “OK”