HP LeftHand SAN Solutions Support Document - Installation Manual - VSA Quick Start Guide for SAN/iQ® 8.0

37
Configuring RAID
If you have configured the data disk in the VI Client as described in Configure
a Data Disk on page 28, RAID will be configured on the VSA. You can continue
configuring the other hardware categories, as described in Configuring
Monitoring and Network on page 38.
However, if you have not yet configured the data disk in the VI Client, you
must configure RAID in the CMC. The VSA comes with one setting provided:
RAID (virtual). This RAID setting must be configured in the CMC before you
can configure storage.
1 In the storage node category tree under the VSA, select the Storage
category.
2 Click RAID Setup Tasks on the RAID Setup tab, as shown inFigure 20.
Figure 20Configuring virtual RAID
3 Choose Configure RAID.
The Configure RAID window opens.
4 Select RAID (virtual) from the list and click OK.
Note that the RAID status now shows normal, as shown in Figure 21.