HP LeftHand SAN Solutions Support Document - Installation Manual - VSA Quick Start Guide for SAN/iQ® 8.0

Figure 16 Configuration Interface window

11 Press Ctrl+Alt to get the cursor back from the Console.

Finishing Up with VI Client

1 In the VI Client Information Panel, click the Summary tab.

2 In the General section on the Summary tab, verify that the IP address and

host name are correct, and that VMware Tools are running.

Note: If VMware Tools show “out of date” then they are running correctly.

The “out of date” status is not a problem. VMware tools are updated with

each SAN/iQ software upgrade.

3 In the inventory panel, right-click the VSA and select Rename.

4 Change the name of the VSA to match the host name, if desired.

Your VSA is ready to use.

5 Minimize your VI Client session.

Next, install the Centralized Management Console (CMC).

Then follow the steps in Getting Started with the Centralized

Management Console on page 35.

Installing the Centralized Management Console

Install the CMC on the computer or virtual machine that you use to

administer the VSA. You administer the entire network of VSAs from this

CMC.

To obtain the latest CMC for the VSA, go to www.hp.com