HP LeftHand SAN Solutions Support Document - Installation Manual - VSA Quick Start Guide for SAN/iQ® 8.0

29
9 Click the Resources tab.
10 Select CPU and reserve at least 2000 MHz.
11 Select Memory and reserve 1024 MB.
12 Click OK to close the Virtual Machine Properties window.
Verify Settings
13 Select the ESX Server in the inventory panel.
14 Click the Resource Allocation tab.
15 Verify the CPU and Memory reservations you just set.
Power On the VSA and Configure IP Address and Host Name
1 In the inventory panel, select the new VSA and power it on using the
Power On command on the information panel.
2 Click the Console Tab and wait for the VSA to boot.
3 When the VSA has finished booting, a log in prompt opens, shown in
Figure 10
Figure 10Logging in to the SAN/iQ Configuration Interface
Note: The first boot of the VSA is longer than normal, since
VMware tools are installed during the first boot up.