HP LeftHand SAN Solutions Support Document - Installation Manual - VSA 8.0 Quick Start - Demo Version

38 Chapter 2
Figure 19 Configuring the hardware
Configuring RAID
If you have configured the data disk in the VI Client as described in Configure
a Data Disk on page 28 RAID will be configured on the VSA. You can continue
configuring the other hardware categories, as described in Configuring
Monitoring and Network on page 40
However, if you have not yet configured the data disk in the VI Client, you
must configure RAID in the CMC. The VSA comes with one setting provided:
RAID (virtual). This RAID setting must be configured in the CMC before you
can configure storage.
1 In the storage node category tree under the VSA, select the
Storage category.
2 Click RAID Setup Tasks on the RAID Setup tab, as shown in Figure 20.