HP LeftHand SAN Solutions Support Document - Installation Manual - VSA Quick Start Guide for SAN/iQ® 8.0

3 Click Next on the Find Nodes Wizard and proceed through its steps.

The wizard guides you through the steps for finding a VSA on your

network. After finishing the wizard, the VSA appears in the navigation

window in the Available pool, shown in Figure 18.

Figure 18 Newly found VSA in CMC

Configuring the Hardware

Configure hardware settings before you add the VSA to a management group.

Select the VSA in the navigation window to expand the hardware

configuration categories. Use these categories to configure RAID (if

necessary), monitoring, and the network, shown in Figure 19.

Figure 19Configuring the hardware

Configure

monitoring, RAID,

and network from

these categories