HP LeftHand SAN Solutions Support Document - Installation Manual - VSA Quick Start Guide for SAN/iQ® 8.0

32
Using DHCP
a Tab to the choice Obtain IP address automatically using DHCP and
press Enter to select it.
b Tab to OK and press Enter.
A message opens, asking you to verify the request.
c Tab to OK and press Enter.
After a short pause, another message opens that displays the new IP
address. Record this IP address for later use.
Configure IP Address Manually
a Tab to the choice Use the Following IP Address and press Enter.
The IP Address, Netmask, and Gateway list opens for editing.
b Tab to each field and enter the appropriate information.
Gateway is a required field. If you do not have a gateway, enter 0.0.0.0.
7 Tab to OK and press Enter.
A confirmation message opens.
8 Press Enter.
The network interface is now configured (wait a few seconds). The
Available Network Devices window opens.
9 On the Available Network Devices window, tab to Back and press Enter to
return to the Configuration Interface menu, shown in Figure 15.
Figure 15Logging out of Configuration Interface menu
10 Tab to Log Out and press Enter.
The Configuration Interface entry window is displayed again.