HP LeftHand SAN Solutions Support Document - Installation Manual - VSA Quick Start Guide for SAN/iQ® 8.0

19
• “Installing the VSA”
• “Getting Started with the Centralized Management Console”
• “Next Steps”
Troubleshooting
Try these tips if you are having trouble.
Table 1 Troubleshooting Installation
Trouble Solution
You want to reinstall
the VSA.
1 Close your CMC session.
2 In VMware, power off the VSA.
3 Click File>Remove from inventory.
4 In a file manager, go to the folder that
holds the VSA.vmx file and delete all files.
5 Copy fresh files into the VSA folder from
the downloaded zip file.
6 Open VMware and begin again.
You cannot find the VSA with
the CMC, and cannot recall
its IP address.
Open a VMware console session and display
the console window for the VSA. Wait for the
SAN/iQ Welcome window and the prompt to
type START and press Enter. In the
Configuration Interface navigate to the
Network TCP/IP settings and select eth0 to
open the Network Settings window. Note the
IP address in that window.
Type the IP address in the NOTES area on
the VMware summary window.
In Windows