HP LaserJet P2015 - Software Technical Reference

If you are installing the printer using a network connection, continue with the following steps.
4. Click Add (or the Set Up Printers... button in the Print & Fax screen, and then Add) to open the
add printer screen.
Figure 5-19 Add printer screen
5. Select the network connection protocol in the top pull-down menu. The two supported protocols
are Rendezvous and IP Printing.
If you are using Rendezvous, carry out the following step:

Select the HP LaserJet P2015 in the Name list. The Printer Model and Model Name are
selected automatically.
NOTE: If the HP LaserJet P2015 does not appear in the list, verify that the printer is powered
on and connected to the network. If it still does not appear, try turning the printer off and then
on again. Finally, turn the computer off and then on again, then restart the setup process. For
more troubleshooting information, see
Troubleshooting the printer setup on page 218.
NOTE: If the automatic selection fails, or if you want to manually select a .PPD file, click
the Printer Model pull-down menu, select HP, and then select the .PPD file that you want to
add. If the HP LaserJet P2015 Series PPD does not appear in the Model Name list, turn the
computer off and then on again and restart the setup process.
If you are using IP Printing, carry out the following steps:
a. Select Socket/HP Jet Direct from the Printer Type pull-down menu. This is the
recommended setting for HP printers.
b. Print out the printer configuration pages. On the printer, press and hold in the green button
for eight seconds, or until you see the LEDs above the button start to blink. The printer prints
out the configuration pages.
ENWW Macintosh install and uninstall instructions 215
Macintosh