Use Guide - Appendix B: Control Panel Menus

Appendix B Control panel menus 183
Configure device menu
STAPLES=NONE Values vary
depending on the
output device
attached
If stapling is requested, indicates where the staple is placed and how
many staples are placed.
If a stacker is attached to the printer, stapling is not an option.
If a stapler/stacker is attached, you can choose the following values:
NONE
ONE (upper-left corner)
ANGLED (upper-left corner)
TWO
THREE
SIX
CUSTOM (only if the stapler/stacker has a definition for "custom")
Note Because of paper size, paper orientation, and
paper feed direction, you should experiment with
staple options to find the results you want.
If a multifunction finisher is attached, you can choose the following
values:
NONE
ONE
TWO
SADDLE STITCH
Item Values Explanation