- HP Laserjet Enterprise 700 Manual

Main drive assembly
1. Remove the following components or assemblies:
●
Rear cover. See
Rear cover on page 13.
●
Formatter cage. See
Formatter cage assembly on page 52.
●
DC controller PCA. See
DC controller PCA on page 96.
2. Remove three screws (callout 1), remove the gear assembly (callout 2), and then release the cables
(callout 3) from the cable guide.
Figure 1-89 Remove the main drive assembly (1 of 7)
1
3
2
3. Release two tabs (callout 1), and then remove the cable guide (callout 2).
Figure 1-90 Remove the main drive assembly (2 of 7)
2
1
60 Chapter 1 Removal and replacement ENWW