- HP Laserjet Enterprise 700 Manual
Tray 4, Tray 5, and Tray 6 pickup and feed rollers
NOTE: The same removal procedures apply to the 1x500-sheet tray, the 1x500-sheet tray stand, and
the 3x500-sheet tray stand.
1. Remove the tray from the product, and then locate the rollers on the right-hand side of the tray
cavity.
Figure 1-5 Remove the 1x500 or 3x500 rollers (1 of 2)
2. Release three tabs, and then pull the rollers in the direction of the arrow.
Figure 1-6 Remove the 1x500 or 3x500 rollers (2 of 2)
Reinstallation tip When you reinstall the rollers, make sure that the rollers snap into place.
ENWW
Pickup rollers
7