- HP Laserjet Enterprise 700 Manual

6. Slide the high-voltage power supply assembly (callout 1) downward slightly and remove it from the
product.
Figure 1-150 Remove the high-voltage power supply assembly (5 of 5)
1
DC controller PCA
1. Remove the following components or assemblies:
●
Rear cover. See
Rear cover on page 13.
●
Formatter cage. See
Formatter cage assembly on page 52.
2. Disconnect all of the connectors on the DC controller PCA, remove four screws (callout 1). release
one tab (callout 2), and then remove the DC controller PCA (callout 3) from the product.
Figure 1-151 Remove the DC controller PCA
1
2
3
96 Chapter 1 Removal and replacement ENWW