- HP Laserjet Enterprise 700 Manual

2. Remove the wire (callout 1), disconnect one connector (callout 2), release the cable (callout 3)
from the cable guide, release two tabs (callout 4), and then remove the front fan (callout 5).
Figure 1-136 Remove the front fan
2
3
1
5
4
Reinstallation tip When reinstalling the front fan, make sure that the fan cable (callout 1) and
the fan label (callout 2) are positioned as shown in the figure below.
Figure 1-137 Reinstall the front fan
1
2
NOTE: When reinstalling the ground wire, see the installation tip in Fuser drive assembly
on page 64.
88 Chapter 1 Removal and replacement ENWW