Administrator's Guide

ENWW TCP/IP Configuration 20
Table 3.1 Tags Supported in a BOOTP/DHCP Boot file (1 of 3)
Item RFC
2132
Option
Description
nodename -- The name of the peripheral. This name identifies an entry
point to a list of parameters for a specific peripheral.
nodename must be the first field in an entry. (In the
example above, nodename is “picasso”.)
ht -- The hardware type tag. For the HP Jetdirect projector
server, set this to ether (for Ethernet). This tag must
precede the ha tag.
vm -- The BOOTP report format tag (required). Set this
parameter to rfc1048.
ha -- The hardware address tag. The hardware (MAC) address
is the link-level, or station address of the HP Jetdirect
projector server. It is printed on a label attached to the
server, and displayed by the embedded web server.
ip -- The IP address tag (required). This address will be the
HP Jetdirect projector server’s IP address.
sm 1 The subnet mask tag. The subnet mask will be used by
the HP Jetdirect projector server to identify the portions of
an IP address that specify the network/subnetwork
number and the host address.
gw 3 The gateway IP address tag. This address identifies the
IP address of the default gateway (router) that the
HP Jetdirect projector server will use for communications
with other subnets.
ds 6 DNS (Domain Name System) server’s IP address tag.
Only a single name server can be specified.
lg 7 The syslog server’s IP address tag. It specifies the server
that the HP Jetdirect projector server sends syslog
messages to. For more information, see Appendix A
.