Latest News: Firmware Version 5.30 - 5969-6812

Latest News: Firmware Version 5.30 9
Pure IP for Novell NetWare
Documentation Notes
❏
In the
User’s Guide
, the “Novell NetWare/IP” section near the
end of chapter 5 is replaced by this section.
❏
In the
Quick Installation Guide
, item 4 under “Step 5. Set up
Novell NetWare (NCP)” should now refer to an additional page
(“
Protocols
”) that you should skip by clicking
[Next >
.
The HP CD/DVD-ROM Server now supports NCP transported over
pure IP. In Novell NetWare 5 environments, the server can be
integrated as any other 5.0 server, accessible using IPX,
NetWare/IP, and pure IP simultaneously. The compatibility mode
of NetWare 4.11 is no longer necessary.
Now, both IPX and pure IP are both enabled by default. NetWare/IP
remains as an option available for NetWare 4.11 environments.
Also, you can disable IPX and run NCP over IP only. See the
following section for these configuration options.
Configuring IP
for Novell
NetWare
1. To use the IP protocol in NetWare, see Novell’s documentation
to make sure that the NetWare TCP/IP environment is fully
implemented first.
2. Configure the server for IP, setting the following parameters.
Refer to the
User’s Guide
or
Quick Installation Guide
.
• IP address (the following items must correspond to it)
• Subnet Mask
• Default Router (gateway)
• Primary DNS Server
• Secondary DNS Server
3. Configure the server for NetWare.
a. Select your protocol combination:
IPX Pure IP NetWare/IP
Instructions
enabled enabled disabled
For NetWare 5.0. These default settings
already configured; no other step needed.
disabled enabled disabled
For NetWare 5.0. Before disabling IPX,
see
Note
below. Go to step b.
enabled
disabled enabled
For NetWare 4.11. Go to step b.
(Before disabling IPX, see
Note
below.)
disabled
enabled
enabled enabled
For NetWare 4.11 and 5.0. Go to step b.
(Before disabling IPX, see
Note
below.
disabled