HP SureStore HD Server 4000 User's Guide - 5967-9979

8
-
8 Adding a Tape Drive
Attaching an External Tape Drive
You can install an tape drive listed in the “External tape drives”
table on page 8-1.
1. Unpack the tape drive product. Verify that you have the
following components. Other materials are not applicable to the
HD Server.
• Tape drive unit
• SCSI terminator attached to back of unit, or separately
available.
• SCSI cable
• Power cord
• Data cartridge: DDS-3 for DAT24i, DDS-4 for DAT40i, or
DLT tape IV for DLT products
• Cleaning cartridge
• Customer care and Warranty
• Electronic
User’s Guide
on
HP SureStore Tape CD-ROM.
Useful instructions include:
• Ordering Information
• Loading and unloading a cartridge
• Cleaning with the cleaning cartridge
Other instructions are not applicable to the HD Server.
2. If the server is
not
powered on, skip to step 6.
3. Notify users of the interruption in service while the server is shut
down. Recommend that users close all files.
4. Shut down the server
,
using one of the following methods.
• Use the control panel’s view mode, as follows: Press
✔
twice. Use the
▲
or
▼
button to scroll to the
Shutdown
Server
parameter. Press
✔
and confirm with
✔
again.
• Use HD Server Admin’s
Configuration Æ
Shutdown/Restart
page. Click
Shutdown and Restart
and
[Apply]
.
5. When you see the following display on the control panel, use the
power switch to switch the server’s power off.
6. Remove the SCSI terminator from the SCSI connector on the rear
of the server, if it remains installed. Reserve the terminator.
Note:
SCSI ID 5
7. On the tape drive unit, set its SCSI ID to 5. Refer to the electronic
User’s Guide
on the
HP SureStore Tape CD-ROM
for instructions.
Power off or
✔ to restart