HP SureStore HD Server 4000 User's Guide - 5967-9979

8
-
6 Adding a Tape Drive
15. Use the Torx #15 screws that you removed with the filler panel in
step 13 above, to secure the tape drive module to the enclosure.
16. Inside the enclosure at the rear of the tape drive, attach the SCSI
cable connector labeled “Tape” to the SCSI connector or adapter
at the back of the drive. (“Tape” faces upward.) Push on the white
tab to slowly and firmly push the connector. (See illustration
below.) When fully secured, the two levers at the sides of the
connector will pop outward.
If installing an HP DAT24i drive, a 68-pin female to 50-pin
female SCSI adapter is required. You can order HP part
number 5064-4688.
CAUTION!
❏
Do
not
push on the levers to secure the SCSI connector. Push on
the back of the connector on the SCSI cable instead. Care and
firmness are required due to the large number of small pins.
Attach SCSI
cable
connector:
Push on
white tab.
Do not push on
side levers.