HP SureStore HD Server 4000 User's Guide - 5967-9979

Adding a Tape Drive 8
-
3
4. Attach the tape drive into the L-series mounting tray: Use the four
Phillips screws provided in the screw kit. Use the topmost
mounting holes in the tray. The tray extends from the back of the
tape drive. See the illustration.
5. If the server is
not
powered on, skip to step 9.
6. Notify users of the interruption in service while the server is shut
down. Recommend that users close all files.
7. Shut down the server
,
using one of the following methods.
• Use the control panel’s view mode, as follows: Press
✔
twice.
Use the
▲
or
▼
button to scroll to the
Shutdown Server
parameter. Press
✔
and confirm with
✔
again.
• Use HD Server Admin’s
Configuration Æ
Shutdown/Restart
page. Click
Shutdown and Restart
and
[Apply]
.
8. When you see the following display on the control panel, use the
power switch to switch the server’s power off.
9. Disconnect both power cords from the rear of the server.
WARNING!
❏
Never open the side door of the enclosure when power cords are
attached. You risk electrical shock even when the power switch
is off.
10. Use the server’s key to unlock the enclosure keylock if necessary.
(See illustration on page 2-7.)
Power off or
✔ to restart
Secure screws in upper
mounting holes.
Tape drive
Tray