HP SureStore HD Server 4000 User's Guide - 5967-9979

Shutting Down and Restarting 6
-
7
Reset to
“First Time”
Defaults
Procedure
Once the server has been installed, its configuration can be changed
by using the control panel during initialization or by using
HD Server Admin after initialization. But if your changes produce
errors so serious that you cannot succeed in changing back to a
working configuration, then you can return to the networking
configuration for the first-time installation by using this procedure.
You may also need this procedure if you redeploy the server (and
you may need to recreate the volume, per page 4-9).
This operation does
not
affect the file system. It does
not
change the
current configuration of the volume, shares, users, groups, and
backup schedule.
This procedure must be done from the initialization state, at the
control panel, as follows:
1. Restart the server. When the control panel displays
Press ✔ to
enter Setup Mode
, press
✔
before the countdown completes.
When prompted
Use ✔ to select
, press
✔
again.
2. Use the
▼
button to scroll to the
Reset Defaults
parameter and
press
✔
.
3. When prompted
Press ✔ to reset network settings
, press
✔
.
4. When prompted
Turn off and restart server
, press the power
switch to switch power off.
5. Wait 10 seconds for the disk drives to stop spinning. Then switch
on the power switch. Follow the initialization process starting at
step 4 on page 2-8—as if you are installing a server for the first
time.
The resulting default settings are described in the following table.