HP SureStore HD Server 4000 User's Guide - 5967-9979

Shutting Down and Restarting 6
-
3
5. If you do press
✔
before the countdown of 10 seconds is completed,
you will be prompted for the control panel password if you have
set one. (See “Change Password” in the table on page 3-6.)
The first character position on the second line of the display is
flashing. To specify each character, you may:
• Press ▲ (up button) on the control panel to cycle through
each letter of the alphabet and each digit.
• Press ▼ (down button) on the control panel to cycle through
each letter and digit in the opposite sequence.
• Accept the character by pressing ✔. The next character
position flashes. Specify that character in the same way.
• You may go back (left) by pressing ✘ for each character until
the needed character is flashing. Then press ▲ or ▼ to
change it.
When the password is complete, press ✔ at the first blank
character position.
6. The control panel display alternates the following instructions for
setup mode:
Press any control panel button to proceed with setup mode, and
refer to page 3-1 for more information on control panel usage.
Return to step 7 below after you complete the setup mode tasks.
7. Startup will continue until the server is ready for normal
operation, which is described on page 6-4.
During this time, the server establishes the link speed—10 or
100 megabits per second—and duplex setting—full or half—to
match the attached network.
Enter Password:
Use Ç or È
key
to move up/down
Use
✘
to cancel
Use
✔
to select