HP SureStore HD Server 4000 User's Guide - 5967-9979

4
-
6 Configuration Using a Browser: HD Server Admin
Network
Configuration
Configuration
Æ
Network
Æ
TCP/IP
page
Changes to all parameters on this page take effect after the next
restart (see page 4-13).
IP Addressing You may manually specify the IP address, the subnet mask, and the
default gateway (router), or you may have them assigned
automatically by a DHCP or BOOTP server.
The assignment method and addresses are not defaulted. They
must be specified at the control panel when the server is started for
the first time.
DNS For domain name resolution for e-mail and SNMP notification,
configure the name of the domain, and specify the address of the
primary domain name server, and the secondary if needed. This is
not set by default.
Note ❏
You must manually add a DNS entry for this server in your
DNS database if you wish to access it by the server name rather
than IP address.
Configuration
Æ
Network
Æ
Microsoft Networking
page
Changes to all parameters on this page take effect after the next
restart (see page 4-13).
Workgroup or
Domain
For the
Workgroup/Domain
name setting, configure the name of
the workgroup or Windows NT domain (whichever you are using)
for the server. The default is the workgroup “
WORKGROUP
”.
If you are using an NT domain, in addition to its name also specify
the Windows name and address of the primary domain controller
(PDC). This is needed for services such as DHCP and WINS.
Note ❏
If you are using
Passthrough Authentication
(see page 4-11),
this
Workgroup/Domain
setting must contain the name of the
NT domain corresponding to the authentication server specified
in the
Server Name
and
Server IP
address settings.
Microsoft WINS You can enable and specify the IP address of a Microsoft Windows
Internet Naming Service (WINS) server. It is not set up by default.
The
NetBIOS Node Type
is defaulted to a setting appropriate to the
setting of
Enable WINS
. A change is usually not required.
(For the SNMP configuration, see page 4-12.)