HP SureStore HD Server 4000 User's Guide - 5967-9979

3
-
6 Configuration Using the Control Panel
Reference Table:
Control Panel Parameters, Menus, and Settings
Parameter In Setup Mode In View Mode Description
IP Method
*
Settings menu:
Manual
DHCP/BOOTP
Show setting only Selects the mechanism for determining the IP
address, subnet mask, and default gateway.
IP Address
*
‡
Edit the default:
000.000.000.000
Show setting only The Internet address of the server. The default
setting 000.000.000.000 is an illegal IP address.
Subnet Mask
*
‡
Edit the default:
255.255.255.000
(for example)
Show setting only Determines when the traffic is directed through a
gateway. The default you see depends on the class
of IP address that is set (example is class C).
Default
Gateway
*
‡
Edit the default:
000.000.000.000
Show setting only Address of the default router or gateway, through
which all traffic directed outside the local network
(according to the subnet mask) is directed. The
default is that no default gateway is set.
Link Speed
*
Settings menu:
Auto (default)
10 Half
10 Full
100 Half
100 Full
Show detected
speed followed by
current setting:
… (Auto)
… (10H)
… (10F)
… (100H)
… (100F)
No link
You can view the actual speed & duplex mode
detected, followed by current setting in
parentheses, e.g. 100 Half (Auto). Meaning of
settings:
Autodetect and set network speed & duplex mode.
(10H)Fix speed to 10Base-T, half duplex.
(10F)Fix speed to 10Base-T, full duplex.
(100H)Fix speed to 100Base-T, half duplex.
(100F)Fix speed to 100Base-T, full duplex.
The setting is not in effect: network not connected!
Auto Restart
*
‡
Settings menu:
On
Off
(default)
Show setting only Specifies whether the server will automatically
restart (up to 3 times) after a critical error, or
whether it will halt.
Alerts Viewer
Not available
in setup mode
Show list only
no Alerts
(default)
Displays a list of scrolling alert messages. Alerts
can be cleared by pressing
✔
.
MAC address Show setting only
(set at factory)
Show setting only Displays the hardware (LAN) address of the
server.
Firmware Ver. Show setting only Show setting only Displays the running firmware version
ROM Version
Show setting only Show setting only Displays the firmware version of the boot ROM
code.
Reset
Defaults
Prompt:
Press
✔
to begin
Not available in
view mode
Sets some parameters on control panel (
*
) and in
HD Server Admin to defaults for first installation.
Change
Password
Prompt:
Press
✔
to begin
Prompt:
Press
✔
to begin
Allows you to specify a control password to control
access to these menus.
*
marks parameters affected by Reset Defaults
‡
marks parameters also set using HD Server Admin, the embedded administration tool