HP SureStore HD Server 4000 User's Guide - 5967-9979

Installation 2
-
11
Optional:
Additional
Control Panel Changes:
Password,
Auto-Restart,
Link Speed
9. Refer to the table on page 3-6 for any setup changes you want to
make on the control panel. Examples of setup changes are:
• You may set a password to limit access to the control panel.
Set the
Change Password
parameter.
• You may want the server to automatically attempt to
restart following critical errors rather than halt and wait.
Set the
Auto Restart
parameter.
• If you must set a specific link speed or duplex mode, rather
than have them set automatically, set the
Link Speed
parameter.
Scroll to the desired control panel parameter. Use the following
buttons (as indicated by the scroll symbol

in the top line of
the display):
▼
to scroll “down” to the next parameter in the list
▲
to scroll “up” to the previous parameter in the list
To select the parameter for modification, press
✔
(when the
scroll symbol

is in the first line of the display).
Use the
▲
and
▼
buttons to scroll through the choices of
settings (when the scroll symbol

or flashing characters are in
the second line of the display) or to edit characters in the
setting. Press
✔
to accept the setting.
(A table listing the behavior of all the buttons is in “Control
Panel Reference” on page 3-1.)
No Further Control
Panel Changes
10. Exit the control panel setup mode to proceed with server
initialization. Press
✘
to cancel; The following displays:
Press
✔
to confirm the exit.
Note:
If your IP address, subnet mask, and gateway
settings (done in steps 6, 7, and 8 above) are inconsistent
when you attempt to exit, the error message shown below
displays for three seconds.
In response, press
✔
or wait for three seconds. Return to
one of the three addressing parameters to correct the
inconsistency (see page 2-9). If you do exit without
correcting the error, the server may be inaccessible on the
network.
Exit Setup Mod
e ?
✔
= Yes,
✘
= N
o
Gateway, Subnet
or IP invalid