HP SureStore HD Server 4000 User's Guide - 5967-9979

2
-
10 Installation
Subnet Mask 7. Press
▼
to scroll down to the next parameter, the IP subnet mask.
The subnet mask determines what traffic should be sent to the
gateway and what traffic stays on the local segment. You will see
a default based on the class of IP address you set in step 6 above.
An example for class C is shown below:
To change this parameter, press
✔
to select it. Then specify the
subnet mask in the same format and with the same procedure
as described for the IP address in step 6 above.
Default Gateway 8. Press
▼
to scroll to the next parameter, the default gateway
(default router) address. All traffic directed outside the local
network—according to the subnet mask (step 7 above)—is sent to
this default gateway. The default 000.000.000.000 specifies that
no default gateway is set.
To change this parameter, press
✔
to select it. Then specify the
gateway address in the same format and with the same
procedure as described for the IP address in step 6 above.
When the addresses are set up, you have configured the
minimum requirements to put the server on the network so that
you can make a remote connection and use the embedded web
interface to make further configuration changes before
providing client access.
Subnet Mask 
=255.255.255.000
Default Gateway 
=000.000.000.000