HP SureStore HD Server 4000 User's Guide - 5967-9979

2
-
6 Installation
Preparation Checklist
10T_____ 100T_____
Autonegotiate?_____
❏
Verify that a 10Base-T (Ethernet) or 100Base-TX
(Fast Ethernet) network cable with an RJ-45 connector is ready
for the server.
❏
Determine how the IP addresses are assigned on the network
for the server. The HD Server provides the following choices.
DHCP
/
BOOTP
server__ • The server can use DHCP (Dynamic Host Configuration
Protocol) or BOOTP (Bootstrap Protocol) for automatic
assignment. For BOOTP service, configure the address for
the HD Server on your BOOTP server before proceeding.
For DHCP service, you may wish to assign a static address
to the HD Server, or you can allow dynamic IP assignment.
Consult your documentation for the service you select.
IP addr____________
Mask______________
Gateway___________
• Otherwise, the server must use manual IP address
assignment. In this case, determine the IP address, the
subnet mask, and the default gateway (router), if any.
2 power sources_____
❏
Locate two power sources for plugging in both redundant power
supplies on the server.
Power is off____
❏
Verify that the main power light above the power switch is off
(illustrated on page 2-7). If it is on, disconnect power.
CAUTION!
Input Voltage____
100-127__ 200-240__
2 power cords____
❏
Verify that the power supply input voltage is set according to
the power standards in the country of use; set the two voltage
switches on the rear of the enclosure (see the rear view on
page 2-7) to 115 volts or 230 volts. Also verify that the power
cords are appropriate for the country of use (see page 2-3 for a
list).
Options installed____
❏
Install any optional hardware: additional disk drives, tape
drives, rack mounting. See “Adding Modules” on page 2-5.