HP SureStore HD Server 4000 User's Guide - 5967-9979

Resolving Problems with Your Server 11

11. Inside the enclosure, find the unattached connector on the power

cable. Attach it to the tape drive’s power connector or to the power

extender cable. See the illustration below. It is keyed to fit only

one way.

12. Check that the red button at the near end of the server module

(above the tape drive module) is in its most fully “out” position.

13. Do the procedure “Close the Enclosure and Start Up” on

page 11-27.

Replace the

Server Module

1. Assemble the following tools:

• Torx

#15 driver or flat-blade screwdriver for filler panel

• Flat-blade screwdriver for opening the enclosure

• HD Server’s enclosure key for opening the keylock

2. Do the procedure “Open the Enclosure” on page 11-25.

3. Detach the old server module at the front of the server (illustrated

below), using the Torx

or screwdriver to remove the two screws.

Reserve them for attaching the new server module.

Power

cable

Tape drive

power

connector

or extender

Remove

screws