HP SureStore HD Server 4000 User's Guide - 5967-9979

Resolving Problems with Your Server 11
-
25
8. Press the drive lever down until it latches. The module fully
engages, while the locking tab and pin snap into place. Both the
front of the module and the drive lever are flush with the adjacent
surfaces in this position.
9. Lock the drive keylock if desired to prevent drive removal.
10. If the server is powered on and ready to restart, at the control
panel press
✔
to restart.
11. Return to the
Configuration
Æ
Disk Setup
page in HD Server
Admin.
• If your volume is OK or degraded, use
[Expand Volume]
to
add the drive to the volume (see page 4-8).
• If your volume is failed, use
[Create Volume]
(see page 4-9).
Then restore all the volumes’s data from backups. (For
using a local tape drive, see “Restoring Files” starting on
page 9-9.)
Open the
Enclosure
The enclosure must first be opened, according to the instructions in
this section, to do some of the procedures listed below.
•
Replace the internal tape drive (page 11-28)
•
Replace the server module (page 11-31)
•
Reset the passwords (page 11-12)
1. Assemble the following tools:
• a flat-blade screwdriver to open the enclosure door
• HD Server’s enclosure key for opening the keylock
2. If the server is
not
powered on, skip to step 6.
3. Notify users of the interruption in service while the server is shut
down. Recommend that users close all files.
Pushing down the drive
lever to snap module into
place