Fabric OS Message Reference v7.0.0 (53-1002149-01, April 2011)

Fabric OS Message Reference 741
53-1002149-01
ZONE-1057
117
ZONE-1057
Message <timestamp>, [ZONE-1057], <sequence-number>,, WARNING, <system-name>, TI Zone <TI
zone name> has domain <Domain ID of switch with version pre6.4.0> running pre
FOS6.4.0 firmware. TI member (Domain <Domain ID of higher port index>, Index
<Higher port index>) is not supported.
Probable Cause Indicates that an unsupported port index(> 511) is present in the TI zone path.
Recommended
Action
Remove the port index from the TI zone or the routing may not be setup correctly.
Severity WARNING
ZONE-1058
Message <timestamp>, [ZONE-1058], <sequence-number>,, WARNING, <system-name>, Domain
<Domain ID of the switch that becomes unreachable> present in TI zone <TI zone
name> became unreachable due to failover disabled mode.
Probable Cause Indicates that the domain present in the Traffic Isolation (TI) zone path is unreachable. This occurs
if the TI zone paths are unavailable or the TI zone is set up incorrectly.
Recommended
Action
Verify that the paths defined by TI zones are online or remove the domain from the TI zone.
Severity WARNING
ZONE-1059
Message <timestamp>, [ZONE-1059], <sequence-number>,, WARNING, <system-name>, Unexpected
TI routing behavior or a potentially un-routable TI configuration has been
detected on local domain <Domain ID of the local Logical Switch where the error
was detected>.
Probable Cause Indicates that the current fabric topology and TI Zone configuration may result in an unroutable
condition or unexpected routing behavior.
Recommended
Action
Execute the zone --showTIerrors command on the specified switch to report the conflicting
configuration details.
Severity WARNING
ZONE-1060
Message <timestamp>, [ZONE-1060], <sequence-number>,, WARNING, <system-name>, Non-TI and
TI failover-enabled traffic restricted to domain <Domain ID> due to TI
failover-disabled zoning.