HP IP/IPX Printer Gateway for NDPS - (English) Readme (version 3.00b)

HP Printer Gateway upgrade/installation unless the user chooses not to

do so. All other values will not be changed. 50 seconds is the default

value in version 2.10a, and 3 seconds is the default value in this version.

The new default value of 3 seconds for “Timeout to Close Job” minimizes

the delay between print jobs.

This version of the HP Printer Gateway supersedes previous versions.

C. HARDWARE REQUIREMENTS

HP Jetdirect Print Servers

IPX

The HP Printer Gateway supports most HP Jetdirect print servers. However,

some of these older print servers must be upgraded or replaced.

TCP/IP

To print through TCP/IP, this protocol must be supported on the HP Jetdirect

print server. Most of the HP Jetdirect print servers support TCP/IP, with the

exception of the HP Jetdirect 150X (HP product number J2592A) and some older

single-protocol HP Jetdirect print servers.

To find out if IPX or TCP/IP is supported on an HP Jetdirect print server, print its

configuration page.

D. NETWARE OPERATING SYSTEM AND CLIENT SUPPORTED BY THE HP

PRINTER GATEWAY

The HP Printer Gateway supports the following Novell NetWare versions:

• NetWare 5.1 with support pack 6 or later

• NetWare 6.0 with support pack 3 or later

• NetWare 6.5

The HP Printer Gateway supports the following Novell Client software:

• Novell Client v3.32 with support pack 1 or later for Windows 95/98

• Novell Client v4.83 with support pack 1 or later for Windows NT, 2000 and