HP IP Distance Gateway User Guide (5697-2060, June 2012)

Set NTP command
Configures NTP parameters.
Admin sessionAuthority
set ntpSyntax
The following is an example of the set ntp command:Example
mpx110 (admin) #> set ntp
NTP (0=Enable, 1=Disable) [Enabled ]
TimeZone Offset from GMT (Min=-12hrs,Max=12hrs) [-8 ]
IP Address [0] [0.0.0.0 ] 207.126.97.57
IP Address [1] [0.0.0.0 ]
IP Address [2] [0.0.0.0 ]
All attribute values that have been changed will now be
saved.
Set Properties command
Configures CLI properties.
Admin sessionAuthority
set propertiesSyntax
The following is an example of the set properties command:
mpx110 (admin) #> set propertiesA list of attributes with formatting and current
values will
Examples
follow. Enter a new value or simply press the ENTER key to
accept the current value. If you wish to terminate this
process before reaching the end of the list press 'q' or 'Q'
and the ENTER key to do so.
CLI Inactivity Timer (0=Disable 1=15min, 2=60min)
[Disabled]
CLI Prompt (Max=32 Characters) [mpx110 ] RTR1
All attribute values that have been changed will now be saved.
Commands 97