HP Surestore Interface Manager Installation and Cabling Poster

DRIVE 00
DRIVE 01
Drive 0
Slot 3, Bus1
Drive 0
Slot 3, Bus1
Terminator
Bus 1
7 9 1010 1111 12128
Slot #
Bus 2
3 654
Bus and Slot Locations
SCSI Cable Label Placement
Bus 2
Bus 1
DRIVE 0
DRIVE 1
DRIVE 2
DRIVE 3
DRIVE 4
DRIVE 5
DRIVE 6
DRIVE 7
DRIVE 8
DRIVE 9
10/180
LIBRARY
T
1
1010
9
8
7
6
4
3
2
T = Terminator
T
T
T
T
T
T
T
T
T
5
Drive 0 Slot 3 Bus 1
Drive 1 Slot 3 Bus 2
Drive 2 Slot 4 Bus 1
Drive 3 Slot 4 Bus 2
Drive 4 Slot 5 Bus 1
Drive 5 Slot 5 Bus 2
Drive 6 Slot 6 Bus 1
Drive 7 Slot 6 Bus 2
Drive 8 Slot 7 Bus 1
Drive 9 Slot 7 Bus 2
01
02
03
04
05
06
07
08
09
10
4
5
6
7
Slot #
3
4
3
0
1
2
5
6 8 10 12 14
79111315
Cabling Diagram for
hp surestore 10/180 library
Installing Fibre Channel Interface Cards
Before iinstalling tthe FFibre CChannel iinterface ccards, rrefer tto CChapter 33 ((Installation) iin tthe HHP
Surestore IInterface MManager IInstallation aand SService GGuide ffor IIMPORTANT iinformation rregarding
the iinstallation oof FFibre CChannel iinterface ccards.
CAUTION:
Standard performance Fibre Channel interface cards are
NOT
supported in the Interface
Manager. The unsupported cards have part numbers C7200-60x09 and C7200-60x16.
These can be easily identified because they have the larger 68-pin SCSI bus connectors.
Inserting these cards into the Interface Manager will result in blowing a fuse, which will
require the replacement of the entire Interface Manager chassis.
CAUTION:
Turn off all devices before making SCSI connections. Failure to turn off all power could
result in damage to the devices.
To install a Fibre Channel interface card:
1) Remove the card slot covers from all slots where a Fibre Channel interface card will be installed.
2) Gently push the card into place by applying pressure on the top
AND
bottom of the card until it is
flush with the chassis. Pushing the card in from the top
OR
bottom alone may damage the card
or the Interface Manager.
1
3
5
4