HP Intelligent Infrastructure Analyzer Software v2.1 Quick Start Guide

Reporter
Generates current report for active profile, and historical reports for any profile. The information in
each report includes SAN inventory, SAN topology, Events, and Diagnostics.
NOTE: Creation of historical reports can take time, depending on the parameters specified.
System requirements for HP IIAS management station
The following are the system requirements for HP IIAS management station:
Table 1 System requirements for HP IIAS management station
Supported platforms, versions, or configurationHardware and software
Dual-core 2.0 GHz CPU or betterCPU
4 Gb or higherRAM
250 MB
NOTE: Minimum 250 MB disk space is required on the drive where TEMP folder
is located.
Product installation disk space
requirements
300 - 350 MBMinimum disk space requirement
NOTE: Disk space will increase depending on the SAN size.
Version 8.0, 9.0, or 10.0/11.0 (compatibility view only).Internet Explorer
HP IIAS v2.0/v2.1 does not work on Windows with KB2846071 service pack .
KB2846071 service pack has a session management issue. Please see Microsoft
site for more details.
NOTE: To enable compatibility view on IE10 and IE11:
• In IE, go to Tools menu, click Compatibility View Settings .
• Select the Display all websites in Compatibility mode check box.
See “Installing OS specific service packs for supported platforms and service
packs” (page 5).
Windows
HP IIAS supports IPv4 only. The host where HP IIAS is installed must have IPv4
address.
IP network addresses
Virtual or Physical.Host Type
NOTE:
• The host on which HP IIAS is installed should be able to connect to the components in the active
profile over Ethernet always.
• Following are the default TCP/IP ports used by HP IIAS:
8080, 8085, 9000, 9001, 5678, 8765
If these ports are used by another application, then the HP IIAS installer prompts to enter the free
ports that can be used.
4 System requirements for HP IIAS management station