HP vPars and Integrity Virtual Machines V6.1 Release Notes

Adapters:
• Broadcom: Device Level Assignment (DLA)
◦ LOMs: BL8x0c i2, Superdome 2
◦ Stand-Up Cards: AM225A/AM232A/AM233A
◦ Mezzanine Cards: NC532m
◦ Broadcom cards must be running this firmware version or later: ROM Firmware (Boot
code) Version: 6.2.21
NOTE: You can obtain the ROM firmware from HP.COM or the IPF offline CD 1203.
◦ Broadcom VSP and vPars/VMs must be running this minimum driver version: 10GigEthr-02
(iexgbe) B.11.31.1203.
• Emulex: Function Level Assignment (FLA)
◦ Stand-Up Cards: AT118A
◦ CNA Stand Up (NIC only): AT111A
◦ Mezzanine Cards: NC552m
◦ CNA Mezzanine (NIC only): NC553m
◦ Emulex cards must be running this firmware version or later: ROM Firmware Version :
3.X04.356.3
◦ Emulex VSP and vPars/VMs must be running this minimum driver version: 10GigEthr-03
(iocxgbe) B.11.31.1203
NOTE: All drivers must be from HP-UX 11i v3 March 2012 or later.
4.10 Online and Offline Migration Support
The following list provides the supported online and offline migration paths for HP-UX guests:
• Support:
Forward migration — Supported between two VSPs running the same or subsequent vPars
and Integrity VM version (see Table 3 (page 34)).
◦
◦ Backward migration — Supported for a vPar/VM migrating back only to a VSP running
the same version on which the vPar/VM was originally booted (including any vPar and
Integrity VM release patches that were installed on the original VSP) and has not been
rebooted since. As of Integrity VM Version 4.3, a VM can also be migrated back to a
VSP that is running a later version of Integrity VM on which the VM was originally booted.
For example, a VM booted on a VSP running Integrity VM Version 4.2.5, then migrated
4.10 Online and Offline Migration Support 33