HP vPars and Integrity Virtual Machines V6.1 Administrator Guide

NOTE: If you receive the following messages during boot or reboot of a vPars or VM, you can
safely ignore them:
montecito_proc_features: PROC_GET_FEATURES returned 0xfffffffffffffff8
CPU00 failed to synchronize its interval timer with CPU03 within 46 Ticks
CPU00 failed to synchronize its interval timer with CPU04 within 46 Ticks
CPU00 failed to synchronize its interval timer with CPU06 within 46 Ticks
CPU00 failed to synchronize its interval timer with CPU07 within 46 Ticks
CPU00 failed to synchronize its interval timer with CPU02 within 45 Ticks
CPU00 failed to synchronize its interval timer with CPU04 within 41 Ticks
CPU00 failed to synchronize its interval timer with CPU06 within 41 Ticks
CPU00 failed to synchronize its interval timer with CPU07 within 41 Ticks
CPU00 failed to synchronize its interval timer with CPU03 within 43 Ticks
Installing Socket Protocol families AF_INET and AF_INET6
Each subdirectory in /opt/hpvm/guest-images contains a README.txt file that describes
how to install the software for that type of vPar/VM. For information about any additional software
updates that you should also install on your vPar/VM, see the HP-UX vPars and Integrity VM V6.1
Release Notes at http://www.hp.com/go/hpux-hpvm-docs.
8.4 Troubleshooting HP-UX guest creation
The following section describes a problem that might occur during HP-UX guest installation.
8.4.1 The guest hangs in the EFI shell
The guest hangs in the EFI when you are starting the guest and you get the following message:
Shell> \efi\hpux\hpux
'\efi\hpux\hpux' not found
Exit status code: Invalid Parameter
The EFI boot parameters were probably not set up correctly during guest operating system
installation. Choose the correct EFI partition from which to boot. For example:
Shell> fs3:
fs3:\> hpux
Installation continues from the specified partition.
8.4 Troubleshooting HP-UX guest creation 105