iTP Secure WebServer System Administrators Guide (Version 7.5+)

Description
Use the SI_Department directive to initialize a department for later use with anonymous tickets.
After you initialize a department, you can use the departmentID value in Region commands to
divide your content into separate administrative areas.
You also can use this directive to specify department-wide ticket attributes. For more information,
see “Anonymous Ticketing Attributes” (page 174).
See also the SI_Department Region command in “Region” (page 232).
Default
None
Example
SI_Department 25
SI_Department 25 -EnableAnonymousTicketing
SI_Enable
Syntax
SI_Enable { On | Off }
Description
Use the SI_Enable directive to enable or disable the use of Session Identifiers on the iTP Secure
WebServer.
Default
SI_Enable On
Example
SI_Enable Off
SK_CacheExpiration
Syntax
SK_CacheExpiration time-in-seconds
Description
Use the SK_CacheExpiration directive to indicate the time period, in seconds, for which each
of the entries in the session key cache is valid. This value (time-in-seconds) is set for each
entry when the entry is first added to the cache.
The expiration time can be set to a maximum of 24 hours. If you set the time to more than 24
hours, a warning message appears and the actual expiration time is reset to 24 hours.
The iTP Secure WebServer removes an entry from the session key cache if the entry's time has
expired or if the cache is full, in which case all expired entries are removed.
Only a positive integer is accepted as a valid value. If you set an invalid value, the iTP Secure
WebServer prints an error message during configuration-file processing, and startup fails. If you
set the value to a negative integer, an error message is printed.
Setting the value of either SK_CacheExpiration or SK_CacheSize to 0 disables session key
caching. Note, however, that a warning message is printed if only one of these configuration
directives is set to 0. Therefore, to disable session key caching, you should set both directives to
0.
SI_Enable 255