HP Array Configuration Utility Command Line Interface for Integrity Linux Environments Support Notes Version 8.40

When existing volumes are modified or deleted, or when new volumes are created using
HP ACU-CLI, the operating system will not always be aware of the changes unless the
system is rebooted.
Workaround: You must reboot the system after making changes to existing volumes.
• ACU-CLI cannot delete the last logical disk.
THIS ISSUE WAS FIXED IN hpacucli8.40+hp-fc-enablement-1.1-13.
ACU-CLI cannot delete the last logical disk that connects to the Qlogic Fibre Channel card.
This issue only happens on RHEL5.3, SLES11, RHEL5.4 and SLES10SP3.
Workaround: The last disk can be deleted on RHEL4 and SLES10SP2
• Mount point displays as "None" after mounting the LD into the OS.
THIS ISSUE WAS FIXED IN hpacucli8.40+hp-fc-enablement-1.1-13.
After mounting your logical drive into the operating system and executing the command
"ld <your id number> show", the system displays the message [None] as the status for
the mount points.
Workaround: Execute the command mount from the command line to display the correct
mount points for your LD.
• hpacucli acts abnormal with the qlogic card and the hp-fc-enablement rpm.
THIS ISSUE WAS FIXED IN hpacucli8.40+hp-fc-enablement-1.1-13.
hpacucli fails to delete the last array due to an issue with the qlogic driver and
hp-fc-enablement lib. This issue occurs on RHEL5.3, RHEL5.4, SLES10SP3, and SLES11.
Workaround: This issue fix requires both the qlogic driver and the hp-fc-enablement
lib fix. The target operating systems for the qlogic driver fix are RHEL5.5 and SLES10SP3.
The lib fix issue will be fixed with version 1.1-9. For the RHEL5.4 and SLES10SP3 operating
systems the fix version will be 1.2-1+.
Support
Support for HP ACU-CLI or Smart Array controllers can be obtained at the HP Customer Care
web site at:
http://support.hp.com
Feedback
For feedback or suggestions regarding HP ACU-CLI, e-mail your comments to:
[e-mail]
Support 9