HP Integrated Lights-Out Addendum

Parameter Default value Descriptions
Serial
Command
Line Interface
Speed
9600 This setting enables you to
use the serial port to change
the speed of the serial port
for the CLI feature. The
following speeds (in bits/s)
are valid: 9600, 19200,
38400, 57600, and
115200. The serial port
configuration must be set to
No parity, 8 data bits, and 1
stop bit (N/8/1) for proper
operation. The serial port
speed that is set by this
parameter must match the
speed of the serial port set in
the System ROM RBSU setup.
Minimum
Password
Length
8 This setting specifies the
minimum number of
characters allowed when a
user password is set or
changed. The character
length can be set at a value
from 0 to 39.
Server Name — This setting enables you to
specify the host server name.
This value is assigned when
using HP ProLiant
Management Agents. If you
do not use the agents and
the host unnamed message
appears, you can change it
here. If the agents are
running, the value you assign
can be overwritten.
To force the browser to
refresh, save this setting, and
press F5.
Parameter Default value Descriptions
Authentication
Failure
Logging
Enabled-Every
3rd Failure
This setting allows you to
configure logging criteria for
failed authentications. All
login types are supported
and every login type works
independently. The following
are valid settings:
• Enabled-Every Failure—A
failed login log entry is
recorded after every
failed login attempt.
• Enabled-Every 2nd
Failure—A failed login
log entry is recorded
after every second failed
login attempt.
• Enabled-Every 3rd
Failure—A failed login
log entry is recorded
after every third failed
login attempt.
• Enabled-Every 5th
Failure—A failed login
log entry is recorded
after every fifth failed
login attempt.
• Disabled—No failed
login log entry is
recorded.
Settings (parameters) found on the Services page of the iLO user
interface.
Parameter Default
value
Description
Secure Shell
(SSH) Access
Enabled This setting enables you to specify
whether the SSH feature on the
iLO is enabled or disabled.
Secure shell
(SSH) Port
22 This setting enables you to
configure the iLO SSH port to be
used for SSH communications.