HP iLO Federation User Guide

2. Do one of the following:
• Click New to create a new group membership.
• Select a group membership, and then click Edit.
3. Enter the following information:
• Group Name—The group name.
• Group Key—The group password. The password can be up to 39 characters.
• Group Key Confirm—Confirm the group password.
4. Select from the following permissions when you are adding or editing a group membership.
The permissions granted to the group by the local iLO system control the tasks users of other
iLOs in the group can perform on the managed server.
• Administer User Accounts
• Remote Console Access
• Virtual Power and Reset
• Virtual Media
• Configure iLO Settings
• Login Privilege
For a description of these permissions, see Table 1 (page 9).
5. Click Add Group or Update Group to save the settings.
Removing an iLO system from an iLO Federation group
Use the following procedure to remove an iLO system from an iLO Federation group. To use RIBCL
scripts to remove group memberships, see “DELETE_FEDERATION_GROUP” (page 19).
1. Navigate to the iLO Federation→Group Configuration page, as shown in Figure 1 (page 8).
2. Select the check box next to the group membership that you want to delete.
3. Click Delete.
The following message appears:
Are you sure you want to delete the selected group(s)?
4. Click OK.
Configuring enclosure support for iLO Federation
If you want to use server blades in an enclosure with iLO Federation, the Enclosure iLO Federation
Support setting must be enabled in the Onboard Administrator software. This setting is required
to allow peer-to-peer communication between the server blades in an enclosure. Enclosure iLO
Federation Support is enabled by default. Onboard Administrator 4.11 or later is required to use
this feature.
Using OA to configure Enclosure iLO Federation Support
Use the following procedure to configure an enclosure for iLO Federation Support.
1. Log in to the OA web interface (https://<OA hostname or IP address>).
2. Navigate to the Enclosure Information→Network Access page, and then click the Protocols
tab, as shown in Figure 2 (page 11).
10 Configuring iLO Federation with the iLO web interface