HP iLO 4 User Guide

Table 9 Information provided by Agentless Management and Insight Management Agents
Insight Management Agents
1
Agentless Management with
AMS
1
Agentless Management without
AMS
Component
Server health
• Fans• Fans• Fans
• ••Temperatures TemperaturesTemperatures
•• •Power suppliesPower supplies Power supplies
••• MemoryMemoryMemory
• ••CPU CPUCPU
Storage
• Smart Array• Smart Array• Smart Array
• ••SMART Drive Monitoring SMART Drive MonitoringSMART Drive Monitoring
•• •Internal hard drives attached
to Smart Array
Internal hard drives attached
to Smart Array
Internal hard drives attached to
Smart Array
•• HBAHBA
• Fibre Channel and iSCSI
• Tape
• External storage
• MAC addresses for embedded
NICs
NIC
• Standup and embedded• Standup and embedded
• •MAC and IP address MAC and IP address
•• Link up/Link down trapsLink up/Link down traps
• Teaming information
• VLAN information
Other
• iLO data• iLO data• iLO data
• ••Firmware inventory Operating system information
(host MIB)
Firmware inventory
• Operating system information
(host MIB)
• Performance data
• •Driver/service inventory Configurable thresholds
• Logging events to operating
system logs
• Clustering information
Pre-Failure Warranty
Alerts
• Memory• Memory• Memory
• ••Drives (physical and logical) Drives (physical and logical)Drives (physical and logical)
• CPU
1
The Agentless Management without AMS column represents the basic iLO configuration without AMS or the Insight Management
Agents. HP ProLiant Gen8 server configurations with AMS or the Insight Management Agents provide the same information as the
basic iLO configuration, plus additional information that is listed in the Agentless Management with AMS and Insight Management
Agents columns.
Installing AMS or the Insight Management Agents
AMS is installed automatically when you perform an operating system installation using HP Intelligent
Provisioning or the HP Service Pack for ProLiant. Follow the instructions in this section if AMS is
not installed or if you want to use the Insight Management Agents.
When you are using Agentless Management and AMS, note the following:
• To verify AMS installation, see “Verifying the AMS installation” (page 108).
• HP does not recommend installing AMS at the same time as the Insight Management Agents
and WMI Providers.
Configuring iLO Management settings 107