HP iLO 4 Scripting and Command Line Guide

<IPV6_REG_DDNS_SERVER VALUE="Y"/>
<SNTP_SERVER1 VALUE="2001:DB8:2:1::13"/>
<SNTP_SERVER2 VALUE="2001:DB8:1::13"/>
<!-- Support for the following 5 tags: -->
<!-- iLO 4 - Version 1.30 and later. -->
<!-- iLO 3 - Version 1.60 and later. -->
<!-- iLO 2 - None -->
<DHCPV6_STATELESS_ENABLE VALUE="Y"/>
<DHCPV6_STATEFUL_ENABLE VALUE="Y"/>
<DHCPV6_RAPID_COMMIT VALUE="N"/>
<DHCPV6_SNTP_SETTINGS VALUE="N"/>
<DHCPV6_DNS_SERVER VALUE="Y"/>
MOD_NETWORK_SETTINGS runtime errors
Possible MOD_NETWORK_SETTINGS error messages include:
• RIB information is open for read-only access. Write access is
required for this operation.
• User does not have correct privilege for action. CONFIG_ILO_PRIV
required.
• iLO may not be disabled on this server. This message is sent if ENABLE_NIC
is set to No and the system is a blade.
MOD_NETWORK_SETTINGS parameters
If the following parameters are not specified, then the parameter value for the specified setting is
preserved. Zero values are not permitted in some fields. Consequently, an empty string deletes the
current value in some fields.
ENABLE_NIC enables the NIC to reflect the state of iLO. The values are Yes or No. It is case
insensitive.
SHARED_NETWORK_PORT sets the Shared Network Port value. The values are LOM, FlexibleLOM,
Yes, or No. The Shared Network Port feature is only available on servers with hardware, NIC
firmware, and iLO firmware that supports this feature. This command is supported on all 300, 500,
700 and 900 ML/DL servers, though not all values, (LOM or FlexibleLOM), are supported on
all servers.
• No—Enables a NIC with a jack on the back of the server (a dedicated network port).
• Yes—Enables a NIC that is built into the server (a shared network port). The NIC handles
server network traffic and can, if ILO is configured to do so, handle iLO traffic at the same
time.
• LOM—Enables a NIC that is built into the server (a shared network port). The NIC handles
server network traffic and can, if ILO is configured to do so, handle iLO traffic at the same
time. Not all servers support a LOM.
• FlexibleLOM—Enables an optional NIC that plugs into a special slot on the server. The NIC
handles server network traffic and can, if iLO is configured to do so, handle iLO traffic at the
same time. Not all servers support a FlexibleLOM.
When using the iLO Shared Network Port, flashing the iLO firmware through the XML interface
takes approximately 7 minutes to complete. Flashing the firmware using Shared Network Port with
iLO does not take any longer to complete than using the dedicated iLO management port.
REG_DDNS_SERVER VALUE instructs iLO to register the management port with a DDNS server.
The possible values are Yes or No.
SPEED_AUTOSELECT is a Boolean parameter to enable or disable the iLO transceiver to auto-detect
the speed (NIC_SPEED) and duplex (FULL_DUPLEX) of the network. This parameter is optional, and
the Boolean string must be set to Yes to enable the speed auto-detect. If this parameter is used,
the Boolean string value must not be left blank. The possible values are Yes or No. The parameter
value is case insensitive.
92 RIBCL XML Scripting Language