HP iLO 4 Scripting and Command Line Guide

<VLAN_ID VALUE="1" />
</MOD_NETWORK_SETTINGS>
</RIB_INFO>
</LOGIN>
</RIBCL>
RBSU POST IP example:
<RIBCL version="2.0">
<LOGIN USER_LOGIN="adminname" PASSWORD="password">
<RIB_INFO MODE="write" >
<MOD_GLOBAL_SETTINGS>
<RBSU_POST_IP VALUE="Y"/>
</MOD_GLOBAL_SETTINGS>
</RIB_INFO>
</LOGIN>
</RIBCL>
Shared network port example:
<RIBCL version="2.0">
<LOGIN USER_LOGIN="adminname" PASSWORD="password">
<RIB_INFO MODE="WRITE" >
<MOD_NETWORK_SETTINGS>
<SHARED_NETWORK_PORT VALUE="N"/>
</MOD_NETWORK_SETTINGS>
</RIB_INFO>
</LOGIN>
</RIBCL>
IPv6_ADDRESS support
MOD_NETWORK_SETTINGS supports IPv6. This section of the sample script (shown below) is
commented out by default. Uncomment the parameters as needed to enable them, and disable
(comment out) the equivalent IPv4 parameters. See IPv6 MOD_NETWORK_SETTINGS parameters
for information on the parameters and their values.
<IPV6_ADDRESS VALUE="2001:DB8:2:1::15" PREFIXLEN="64"/>
<IPV6_ADDRESS VALUE="2001:DB8:2:2::15" PREFIXLEN="64"/>
<IPV6_ADDRESS VALUE="FC00:DB8:2:3::15" PREFIXLEN="64"/>
<IPV6_ADDRESS VALUE="FC00:DB8:2:2::15"
PREFIXLEN="64"
ADDR_SOURCE="STATIC"
ADDR_STATUS="ACTIVE"/>
<IPV6_STATIC_ROUTE_1
IPV6_DEST="::"
PREFIXLEN="0"
IPV6_GATEWAY="::"
ADDR_STATUS="INACTIVE"/>
<IPV6_STATIC_ROUTE_2
IPV6_DEST="::"
PREFIXLEN="0"
IPV6_GATEWAY="::"
ADDR_STATUS="INACTIVE"/>
<IPV6_STATIC_ROUTE_3
IPV6_DEST="2001:DB8:2002:3003::"
PREFIXLEN="64"
IPV6_GATEWAY="2001:DB8:1::40"
ADDR_STATUS="ACTIVE"/>
<IPV6_PRIM_DNS_SERVER VALUE="2001:DB8:2:1::13"/>
<IPV6_SEC_DNS_SERVER VALUE="::"/>
<IPV6_TER_DNS_SERVER VALUE="::"/>
<IPV6_DEFAULT_GATEWAY VALUE="::"/>
<IPV6_PREFERRED_PROTOCOL VALUE="Y"/>
<IPV6_ADDR_AUTOCFG VALUE="Y"/>
RIB_INFO 91