HP iLO 4 Scripting and Command Line Guide

◦ oemhp_Gateway3Address
◦ DHCPOptionToUse
Specify one or more properties on the command line. If multiple properties are on the same
command line, they must be separated by a space.
The iLO firmware resets after the network settings have been applied.
For example, the following command sets the iLO network port to the shared network port NIC on
the server motherboard. This NIC is referred to as the LOM elsewhere in iLO documentation. Not
all servers have this hardware.
Set /map1/enetport1/lanendpt1 EnabledState=32768
The following example sets the iLO network port to the optional shared network port NIC that can
be plugged into the server in the FlexibleLOM slot on the server motherboard. This slot is not a
standard PCI slot, but is a special horizontal connector in the back right hand corner of the
motherboard. Not all servers have this slot, or the NIC that plugs into this slot.
Set /map1/enetport1/lanendpt1 EnabledState=32769
iLO 4 settings
The iLO 4 settings commands enable you to view or modify iLO 4 settings. Table 7 (page 44)
shows the iLO 4 properties. The iLO 4 settings are located at:
/map1/config1
Targets
No targets
Properties
Table 7 iLO Properties
DescriptionAccessProperty
Enables or disables iLO. Boolean values are accepted.Read/Writeoemhp_mapenable
Sets session timeout in minutes. Valid values are 15, 30, 60,
and 120.
Read/Writeoemhp_timeout
Enables or disables RBSU prompt during POST. Boolean values
are accepted.
Read/Writeoemhp_rbsuenable
Enables or disables login requirement for accessing RBSU.
Boolean values are accepted.
Read/Writeoemhp_rbsulogin
Enables or disables iLO IP address display during POST.
Boolean values are accepted.
Read/Writeoemhp_rbsushowip
Enables or disables capture of virtual serial port output from the
server.
Read/Writeoemhp_vsp_log_enable
Sets the Remote Console configuration. Valid values are
enabled, disabled, or automatic.
Read/Writeoemhp_rcconfig
Sets the HTTP port value.Read/Writeoemhp_httpport
Sets the SSL port value.Read/Writeoemhp_sslport
Sets remote console port value.Read/Writeoemhp_rcport
Sets virtual media port value.Read/Writeoemhp_vmport
Sets the SSH port value.Read/Writeoemhp_sshport
Enables or disables SSH. Boolean values are accepted.Read/Writeoemhp_sshstatus
44 SMASH CLP Scripting Language