HP iLO 4 Scripting and Command Line Guide

– MOD_FEDERATION_GROUP
– SET_FEDERATION_MULTICAST
◦ Insight Remote Support Direct Connect commands:
DC_REGISTRATION_COMPLETE–
– SET_ERS_DIRECT_CONNECT
– SET_ERS_WEB_PROXY
◦ Boot configuration commands:
GET_CURRENT_BOOT_MODE–
– GET_PENDING_BOOT_MODE
– GET_SUPPORTED_BOOT_MODE
– SET_PENDING_BOOT_MODE
◦ Encryption commands:
– GET_ENCRYPT_SETTINGS
– GET_TPM_STATUS
– MOD_ENCRYPT_SETTINGS
• Updated the following commands:
SET_ONE_TIME_BOOT◦
◦ SET_PERSISTENT_BOOT
HP Insight Control server deployment
HP Insight Control server deployment integrates with iLO to enable the management of remote
servers and to monitor the performance of remote console operations, regardless of the state of
the operating system or hardware.
The deployment server provides the capability to use the power management features of iLO to
power on, power off, or cycle power on the target server. Each time a server connects to the
deployment server, the deployment server polls the target server to verify the presence of a LOM
management device. If installed, the server gathers information, including the DNS name, IP
address, and user login name. Security is maintained by requiring the user to enter the correct
password for that user name.
For more information about the HP Insight Control server deployment, see the documentation that
ships on the HP Insight software DVD, or the HP website at http://www.hp.com/go/insightcontrol.
16 Introduction