HP iLO 3 Scripting and Command Line Guide

• 3—Enabled (records every third authentication failure: this is the default value.)
• 5—Enabled (records every fifth authentication failure)
SSH_STATUS—Determines if SSH is enabled. The valid values are Yes or No, which enable or
disable SSH functionality.
SSH_PORT—Specifies the port used for SSH connection on iLO 3. The processor must be reset if
this value is changed.
SERIAL_CLI_STATUS—Specifies the status of the CLI. The possible values include:
• 0—No change
• 1—Disabled
• 2—Enabled (no authentication required)
• 3—Enabled (authentication required)
SERIAL_CLI_SPEED—Specifies the CLI port speed.
NOTE: The serial port speed set using this parameter must match the speed of the serial port set
in the RBSU.
The possible values include:
• 0—No change
• 1—9,600 bps
• 2—19,200 bps
• 3—38,400 bps
• 4—57,600 bps
• 5—115,200 bps
RBSU_POST_IP—Determines whether the iLO 4 IP address is displayed during server POST process.
The valid values are Y (enabled) or N (disabled).
REMOTE_SYSLOG_ENABLE—Determines whether iLO should send event notification messages to
a Syslog server. Valid values are Y (enabled) or N (disabled)
REMOTE_SYSLOG_PORT—Sets the port number through which the Syslog server listens.
REMOTE_SYSLOG_SERVER_ADDRESS—Sets the IP address, FQDN, IPv6 name, or short name of
the server running the Syslog service.
ALERTMAIL_ENABLE—Determines whether ILO should send alert conditions detected independently
of the host operating system via email. The valid values are Y (enabled) or N (disabled).
ALERTMAIL_EMAIL_ADDRESS—Sets the destination email address for iLO email alerts. Value must
be a single email address no longer than 63 characters, and must be in standard email address
format.
ALERTMAIL_SENDER_DOMAIN—Sets the domain name to be used in the sender (From) email
address. Value is formed by using the iLO name as the hostname and the subject string as the
domain name. If this value is left blank or not specified, the iLO domain name is used (which may
not be accepted by all SMTP servers.) The maximum string length is 63 characters.
ALERTMAIL_SMTP_SERVER—Sets the IP address or DNS name of the SMTP server or the MSA.
This server cooperates with the MTA to deliver the email. The maximum string length is 63
characters. Note that the SMTP server specified must support unauthenticated SMTP connections
on port 25.
IPMI_DCMI_OVER_LAN_ENABLED—Determines whether you can send industry-standard IPMI and
DCMI commands over the LAN using a client-side application. Server-side IPMI/DCMI applications
are still functional even when this setting is disabled. The valid values are Y (enabled) or N (disabled).
RIB_INFO 87